Tap Water Filter With LED Display | Dual Mode Attachment

Screws on in minutes, two flows on a dial, reads at a glance!

Screws onto the end of an existing tap in a couple of minutes, no plumber and no pipework. A dial on the side switches between a wide spray for rinsing vegetables and a straight stream for filling a pan, and the illuminated readout on the front tells you where things stand at a glance rather than leaving you guessing. The cartridge sits in the barrel on top and lifts out for replacement. Nothing about it looks like plumbing hardware, which helps on an open worktop.

• Fits an existing tap: Screws onto the spout in place of the aerator, so there is no plumbing and nothing to disconnect.
  
• Two flow modes: A dial turns between a broad rinsing spray and a straight stream for filling, without reaching under the sink.
  
• Illuminated readout: A lit display on the front face rather than a sticker on the side you have to crouch to read.
  
• Replaceable cartridge: Lifts out of the top barrel by hand, so upkeep does not mean replacing the whole unit.

Specifications

Design: Tap-mounted unit with an upright cartridge barrel, front display panel, side selector dial and twin outlets
Details: Thread sizes and adaptors supplied, cartridge type and life, what the display indicates, flow rate, filtration performance data, power source and materials per supplier sheet
Function: Point-of-use tap attachment with switchable flow modes
Placement: Kitchen mixer or pillar tap, utility room sink
Ideal for: Hard water areas, rinsing produce, filling kettles and pans, renters who cannot alter plumbing